The Mustang Forum for Track & Racing Enthusiasts

Taking your Mustang to an open track/HPDE event for the first time? Do you race competitively? This forum is for you! Log in to remove most ads.

  • Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!

FS: bolt on jack plates for 2015+ Mustang

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

I am going to make a few sets of jack plates that fit the new S550/GT350. They will sell for $130 shipped. You have your choice of powder coating in red or black and they come with grade 8 bolts and install directions. Just beware that they are harder to install on the S550 than the S197 as the pinch weld is now hardened steel, instead of just high strength steel. A regular drill bit will not work. You will need a good 5/16" bit (or two!). Cobalt or carbide. This is the bit Black Boss used to finish drilling his holes with.
https://www.zoro.com/b-a-hard-steel-drill-bit-rh-516-in-4-in-l-sp-9/i/G2450472/

If you want a set, just send me a PM as I am starting on them next week. Mike

SKXWpxZ.jpg

Here are the plates being used on a Boss.

8sBD4Yl.jpg
 
Last edited:
I'll take a set in red. Your paypal is the same as your email I have?
 
I have been thinking about making another batch of five sets of these jack plates. I have one person interested. Anyone else interested? I have received feedback from a couple of buyers of the first batch. They stated that the installers had went thru a couple of bits drilling the pinch weld but they did get them installed.
 
I have a batch of jack plates going to powder coating Friday with a few sets available. If you want a set, let me know as I need to know what color you want, red or black.
 

TMO Supporting Vendors

Top