Long thread, so I'll just post and hope it's not that duplicative.I did it the easier way with just 275/35-19s on each corner. I use 1/8 spacer up front, but not really necessary. I have the Ford Racing full suspension kit, and a steeda adjustable panhard bar. The wheels are from...

This is the Build Thread for Custom Cobra. Reply below.

This is the Build Thread for BMW 230i M Sport. Reply below.

This has always been a difficult debate with the "It's what the factory says" camp, and the "That's just for MPG" camp. Same arguments in the BMW forums.For track duty, this is, IMO, a critical question though, and using 0W-20 seems potentially problematic. Ford is the only manufacturer...

I have another sub-belt that bolts in at back, along with a lap belt plate. So, I have the rear bolts (upgraded 10.9 and longer) bolting down the adapter, lap belt plate and now a sub-belt bar (3 brackets total) in the the back. It works, but wanted to consolidate (back to two) maybe with just...

Can you shoot me a link or pix of the sub-belt mounts...am looking for a set for a 2008 Mustang??

This a Sparco 6-point racing harness. The manufacture date is June 2016 and is a valid FIA harness through 2021. It is a Spec 16.1 standard harness.It was purchased new, installed, but not used on track as I replaced this harness with a different lap belt pull and a more HANS friendly set up...

Can I order a set, or just one (would use one as an adapter when jacking only...if they work that way), for my S197 (2008 GT)? I would take any color in stock, but prefer black.

This is the Build Thread for HPDE & TT Mustang GT. Reply below.

All fine points. This discussion got off the rails, I guess. I decided not to drill out my spot welds after all and will not install the Ford Performance tubular tow bumper. I think that cross piece (which is the main connector for the two longitudinal frame rails), and the welds therein, are...

I like using a thread, however old, if it is accurate to the discussion. Even if old, it gets put to top of recent activity and I hoped it'd yield a useful reply. I'll keep searching...

Need some help. Got the FRPP tubular tow bumper replacement. Cannot get the OE bumper reinforcement piece off of my 2008 GT. I don't see the spot welds between the bumper and the plates...only a few connecting the plates to the car framing; are these the welds that must be drilled out? Is...