Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
I think you can get more than 2.2 with the Vorshlag without cutting. I think I got a little over 3 when I first put them in. Just had to go for more though. It was a very worthwhile thing, that car was on rails.
Let's talk about OP Mustang and what kind of people Tim and Kelly are.
As many of you know from Facebook posts, I suffered another engine failure due to a secondary cam timing chain failure on the right bank of my engine. This caused piston to...
It's funny I did it the other way around from you: I had BMR on my 2019, and I bought Vorshlag for my 2024. I have yet to install them. For having tried both, do you reckon I should get more camber with the Vorshlag, without cutting the strut... (see full post)
It would. But I don't like it. I prefer the car without. The GT-350R brace and the S650 steel brace have similar height clearances. One is lighter than the other. And the S650 GT PP brace has mounting holes for a badge, but no badge! (see full post)
First small change to the car: removed engine cover, and swapped the stamped steel strut tower brace out and put in the GT-350R brace I salvaged from my wrecked 2019 GT.
Pictures before and after (see full post)
Hi Bill, thanks for the reply! The reason I ordered the springs is because I had much lower H&R Super Sports on my S550 with these same wheels (with 395/30/19 tires) and never had a problem with travel or rubbing on or off track.
These springs... (see full post)
Pick the tires you want to run first and then decide on rims from there. Assuming you want 305-ish width (you do), 19's have more 100 and 200tw options while 18's are better for Hoosiers and race tires.
I had a bunch of stop the hop parts and ultimately were heavier, more expensive, and din't work any better than the BMR CB005 that I have now. Highly recommended.
Good afternoon all!
I will finally take delivery of my S650 GT PP Magneride manual. It will be my HPDE +AX car.
Trying to figure out what (mild) suspension setup would be optimal for dual purpose track 10-15 times per year and the occasional...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.