Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!
Had the last codes fixed now this one popped up today at VIR. P0720-output speed sensor circuit The speedo didn't really work, and the shifting was goofy at low speeds, but once I got up to speed the car ran fine. Is this all part of the cheap harness??
Thanks everyone! I got that fixed and now another code popped up today at VIr. P0720 output speed circuit sensor. Speedo doesn't work and the shifting was a little goofy until I got up to speed then shifted fine. Is this part of the "cheap" harness too?
I have a set of Hankook R-S3's that I've used at about 10 track events (VIR) over the last year. They have pretty decent treat left on them in general and haven't started to "chunk" at all. The edges are worn down of course. I have camber plates and a track alignment.I generally run in the...
So brought my car to ford today and they said all they see are misfire codes and will replace the crank sensor. Any thoughts on why they wouldn't see the P0013 & P0015 codes that my scanner picked up?? I told them to check again.
Guys,My boss threw a p0013 code this morning but is running fine. I'm at VIR and have done 3 sessions all out and no issues and no limp mode.I've read that it is likely that sensor or a wiring harness issue.Any thoughts on still driving it? I have all day tomorrow left.Let me know...
It does have similar lines to the 370z. It looks quite a bit shorter, which I don't think I like that much, but I do like the front. Not too bad overall.
How much are you looking to pay? I have two sets of Orem wheels and a few are lightly scratched. I may be willing to sell them. Are you looking for all 4?
Thanks! I'll bring my car to the dealer next week. Where is the helper spring located? I assume under the dash near the pedal???? Is it easy to remove?
Okay, so I have around 30 track days and have had zero issues with my clutch, then today at VIR the pedal decides to stay on the floor or only return about 1/2 way back up. It also feels different letting it back out.After I pulled the clutch back up with my foot, it seemed to be good for...
So my solution for staying planted in my seat is not protective like a roll bar or very sexy, but it does work! So, my solution.... I use one of those baby car seat seat belt locks (little "H" shaped pieces of metal) that is designed to lock the seat belt tight across the car seat. It holds...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.