Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!
Wondering if the 10.5 inch +47 mm PF01's will work on the front of a stock 12 B302 LS ?
Will it clear the brakes and are spacers required. Would like to run 305/315's in all corners.
Will have the MCS struts with Vorshlag c/c plates in the future.
Thanks
Alex of T&A has been involved with suspensions for quite a while. He worked for Ford during the development of the current Ford GT( suspension development) and until recently, was to go to guy for most of the people that put suspension on their GT's. Ohlin's are where people are going for their...
I use the ATE Blue/ 200(Gold) for normal everyday driving. Still a very good DOT4, and about 15-18 dollar a liter. Using this fluid system gives a clear indication when you have completely flushed the old fluid out..
If your pushing the car hard enough on the track to really need Motul or even...
I bought a set of these. Haven't tried them… Bought them for another Ford that doesn't have the new style O2 sensors.. Will install after we get rid of the snow. If it works on that car , I may buy the LTH. Due to my location and state requirements, installing the LTH just to get a CEL, would...
Two inches would be a lot. The seat sits down between the frame tubes and typically is about 1 + inch above the ground. When racing, out west with rocks off course, If you went off track, you needed to be ready to lift your rear so you didn't take a rock at 40-60 mph through the fiberglass...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.