I put the GT 500 quad exhaust valance on my 2013 Boss , I dont recall having to modify anything to make it fit.

All good I'am not going to Ford, feeling pretty stupid though. I usally run a Catch can system , but thought i would leave it off and put the factor PCV system back tempary so I could see around my valve cover for oil leaks. So I guess i hooked up the OEM system but actally forget to put the...

Help please , so I change out this VCT solenoid , started up my car got out on the street started running very bad ( wrench light came on ) put it back in garage , shut it off unplugged Solenoid & plugged back in , restarted ( wrendh light went away ) . Went around the block and idle speed would...

Thanks so much , great info here . Yes I have a 2013 Boss 302 . My original VCT look just like the 2011 model except the plug is 180 degrees. The one Ford sold me looks like the updated version. I took all those numbers off the VCT solenoid , the bag it came in has BR3Z-6M280-E-1X . Looks like I...

My Passenger side intake VCT Solenoid was leaking oil into the electrical plug , the gromet didn't appear to be leaking. I have my Valve cover off ,pulled the old one out PA 6-6 KTK2H / BR3E- 6B297-DB . The new one ford sold me PA 6-6 KTK2H / BR3E- 6B297. They are similiar but the plug is 180...

I had the same issue with a low ceiling , I had one cylinder that was loosing air pressure , Quick jack sent a replacement no questions asked. Its not so quick setting under the Boss , because the car is so low. But once its set it is very solid and safe , very happy with this jack .

Thanks for posting , your car looks amazing . I also have T springs with stock struts . I also want to stay with a 19" Rim. was going to pull the trigger on Apex 19" x !0" square ,But I was concerned the front would rub. How did you like 19" x 10" set up ? and why did you go 19" x 11" ,I...

OK thanks, once I have drained the block , anything I should know about filling it agian ?

I am attempting to change my engine coolant on 2013 Boss 302 , manual calls for 15.2 Q / 14.4 l . I have drained the resevior tank and Radaitor , But it appears i have not drain enough , maybe half . So my question is how do I drain the remaining coolant from the Engine? Thanks.

We have a small track in Mission B.C , the newest track is Area 27 in Oliver B.C. but its a private club. The Car has not seen a track or auto cross lately. just about anything I want to buy for my vehicles comes from US , Shipping to Canada is costly, I use to pick up thing in Sumas just...

Just about got the same Cars , Cortex Watts Link , LCA s, Torque Arm , MGW short throw shifter, DynoTech 1 piece drive shaft , Ford T springs. Peterson catch can, Blowfish shifter suport / drive shaft loop. Corsa axle back quad tip black.

If your installing a Torque Arm the 5 lower bolts will be replaced with new longer 5/16"-18 x 1.75" bolts.

Use Ultra Grey High Temperature Gasket Maker, Do not use a gasket. Make sure to use thread sealant. Back load bolts out to clear the bearing caps but do not remove them .Bolt & washer. Diff cover 25 FT-Lbs.Max. Screw the two load bolts in by hand until they make contact with bearing caps. Torque...

OK , i already have a Boss 302. Probably would of had a LS Boss but they did not sell them in Canada in 2013. Good luck with selling you car.