Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!
My buddy Jay and I installed the Steeda Bump Steer Kit before taking the car to VIR this past weekend for the Full Throttle Fall Fest. What a great time! The car did very well! I ran consistent 2.17s my 2nd event at VIR. Apparently I am figuring that track out :p
Boo! I have a GT and it doesn't have steering angle, gear selection, or brake pedal position. Damn.
The AIM Solo2 DL that connects directly to the CAN bus and bypasses the OBD2 port can get all of that info though, right?
I added MP Concepts Upper and Lower grilles and redid the tow hook.I was running consistent 1.46s at Carolina Motorsports Park during the Carolina Regional Mustang Club's Performance Driving School event on 10/8 and 10/9:
I drove my 2015 Mustang GT at Carolina Motorsports Park in October 2020 and had a super weird issue where oil was coming through my JLT CAI and onto my suspension and then onto my driver side brakes, wheel and tire. This caused an unscheduled off track excursion that ended with my car against a...
Yeah, SC is very friendly to the track oriented. There are no vehicle inspections (and what do you know, the cars are actually ok! ;)), and they even allow for darker window tint!I am a little over 1 hour from Carolina Motorsports Park and about 3 hours from AMP, Road Atlanta, and less than 3...
Yeah, I think you're right, although $700+ is a lot of money for a couple of cast iron rings. I'm sure it is a supply / demand problem.
DBA makes high quality rotors. They even supplied them with painted so that I could see how hot they were getting. That was pretty cool!BTW as an aside, I see...
The Steeda brake rotors met their demise at VIR on November 13th by developing a crack. I switched back to my street rotors/pads for the remainder of the event.I went to purchase the Steeda 2-piece rotor rebuild kit (just the cast iron rotor part) and got some serious sticker shock! They used...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.