So, there are 4 wires that go to where your key goes. Then there is the ignition module on the other side of the ignition cylinder that has 6 wires. Wiring in a remote start button is easy. What I cant figure out is what wires i need to cut and send to a remote switch to making it so when i flip the switch, it is like turning the key to run and then flip it again and like turning the key to off.
I removed my ignition cylinder (Added racing steering shaft) and disabled PATS. Now i just need to cut whichever wire(s) are needed to send to toggle switches so I don't need a key to start the car.
I have looked over wiring diagrams a million times. Any help would be greatly appreciated.
I removed my ignition cylinder (Added racing steering shaft) and disabled PATS. Now i just need to cut whichever wire(s) are needed to send to toggle switches so I don't need a key to start the car.
I have looked over wiring diagrams a million times. Any help would be greatly appreciated.