The Mustang Forum for Track & Racing Enthusiasts

Taking your Mustang to an open track/HPDE event for the first time? Do you race competitively? This forum is for you! Log in to remove most ads.

  • Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!

Laguna Seca Gauges

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

I just had these installed, and I seem to have an issue with mine. I understand that these are autometer gauges (D-PIC) and I can't seem to get mine calibrated right. After a few miles, the real time lateral G meter reads like you are in a left corner. After a bit, as bad as a half G. Anyone else have this issue?

I'm calabrating according to the instructions in the supplement, but I'm also driving off after the gauge says "done." Should I stop after that?

Here is a photo:

553104_10151054394676928_1469780051_n.jpg
 
I was hoping that somebody else has had this issue, before I spend time calling up autometer.

I'm hoping that I am just doing something wrong.

Got the gauges at Blue Oval, which is the best price that I found, and installed by my dealer at a reasonable rate. It's nice having a real temp and oil pressure guage that looks factory.
 

Sesshomurai

This is next on my list as well. But where did you have them installed? Their work should be warrantied I would think.
 
At my local dealership.

The installation doesn't look to bad, honestly, but the part where you spliced into the wiring harness at the very end caused me a bit of concern.

I don't think it installation related, and I'm wondering if it's gauge related, so I was hoping to get some feedback from somebody with them. Oddly enough, once you shut the car down, and restart, it resets at zero, and it is good for a bit, and then back to the imaginary left hand turn.

I'm just going to have to call autometer in a few days.

The package is great, and the cost for the package is because they are all set up with a harness to go into the existing setup. The cheapest I found them was at Blue Oval Industries, who got them right here, and a few hundred bucks from the Ford Dealer to install. All in all, right at the list price from most folks.

http://www.blueovalindustries.com/ads/boss302/ga1480.html


I'm pretty sure this is the same exact gauge:

http://www.autometer.com/cat_gaugedetail.aspx?gid=3284
 
http://www.svtperformance.com/forums/2012-boss-302-mustang-373/863947-laguna-seca-gauges.html

My center gauge is not good. I have to take them out, thank God for the quick connect loom on these, and Ford Racing is going to replace them. Thanks Ford!
 

TMO Supporting Vendors

Top