pufferfish
Supporting Vendor
A while back, it came to my attention that The GT500 folks had a difficult time installing one of my front tow hooks. My bracket mounts to the same location as the heat exchanger and occupies the same space. with a bit of ingenuity, folks have been able to make them piggyback. Well, with the massive aftermarket heat exchangers and intercoolers, as well as the big dog they put in the new '13 GT500, piggybacking is no longer a possibility.
So, in the effort to satisfy the needs of those with GT500's and aftermarket systems, I developed a new design, which will clamp around the bumper beam (much like my rear kit did). This design steers clear of ANY heat exchanger or intercooler. an additional feature is that I offer bolt on splitter strut mounting wings. So, you can now run the big heat exchanger and have the LS splitter. Since the factory LS bracket also bolts to where most of the heat exchangers do, there was some issues with mounting both.
http://stores.blowfishracing.com/-s...m/media/00/a6473911412845f56c22ae_l.jpg[/IMG]
So, in the effort to satisfy the needs of those with GT500's and aftermarket systems, I developed a new design, which will clamp around the bumper beam (much like my rear kit did). This design steers clear of ANY heat exchanger or intercooler. an additional feature is that I offer bolt on splitter strut mounting wings. So, you can now run the big heat exchanger and have the LS splitter. Since the factory LS bracket also bolts to where most of the heat exchangers do, there was some issues with mounting both.
http://stores.blowfishracing.com/-s...m/media/00/a6473911412845f56c22ae_l.jpg[/IMG]