Thanks everyone. One thing to note is it's possible to install the kit without removing the inside panels and leaving the seat belts in place. This will make it much easier for the one or two times a year when I swap them back and fourth.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I didn't measure it but I don't think so. It does come forward of the vertical floor board but by no more than 1/2". It shouldn't interfere with your seat waaaay back.Jeff said:i need this.
one question does the bottom piece hang off any further than the seat did?
I wrapped them so they won't rattle and tucked them under the bottom piece. There's plenty of room. You need to use the mounting holes for the LATCH bars so those come out. They won't be going back in.kona768 said:Did you have to remove the bottom belts also or were you able to tuck those under the kit? Thanks