Dvendet
Everyone's entitled to my opinion. ;)
Wow! Very elegant, but simple solution. I'm impressed. Very nice work. I love the splitters too, but your entire creative solution makes this whole thing work. Look forward to seeing the rear pressure plates when you get those done.908ssp said:The plates at the front of the rockers have nothing to do with this thread. I made those to pull the ends of the K members back in place after I bent them up by putting a jack stand at the end of the K member...So Don't Do That. They started out an inch thick or maybe more there is quiet a bit of mill work on the top side you can't see to make them strong but lighter than they look.
I am making some jack blocks for the rear they will attach right on the rocker near the factory jack points and extend down 1/4" just enough so I can use a flat plate to jack the car up and not put pressure on the side skirts. I'll show you when I am done.
MMD