The Mustang Forum for Track & Racing Enthusiasts

Taking your Mustang to an open track/HPDE event for the first time? Do you race competitively? This forum is for you! Log in to remove most ads.

  • Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!

Watson Racing "Closeout" for Roll Bar Group Buy

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Patrick from WR send me a message wanting to gauge interest in the closeout that will work with their roll bar and your rear seat cushion. One advantage it's an out of the box accessory with no cutting necessary. By using your rear seat cushion you don't have to find a place to store it. Please post if you have interest in this piece and I can work on a group buy.

WR is going to offer these for $225.00 and they will offer BMO members a group buy if there is interest in this product. From Patrick:

"For the 4-point closeout, take a look at the picture labeled “Closeout_Boxed” for reference. The piece is stitched with multiple thin boards sewn within (red boxes- please excuse the incorrect angle) for rigidity. The entire back-side is covered by gray vinyl (also stitched to the carpet) so the appearance is pleasant from inside the trunk. It uses two embedded push-pins (blue circles), using the holes left by removing the rear seat upper latches. We have also sewn in some heavy duty Velcro strips (long blue rectangles). The vertical Velcro strips will stick to the plastic trim panels, and additional Velcro runs along the floor section, to stick it to the floor if you’d like. The ‘cut lines’ in the panel in front of the 4-point diagonal tubes have Velcro sewn in as well, to secure the seam closed after installed around the tubes. Overall, it is a very nice piece that works very well at reducing noise from the trunk; it is almost as effective as the seat itself. Installation time is somewhere along the lines of 5-10 minutes! "

Closeout_1_zps932f8135.jpg
Closeout_2_zpsb3aeeb57.jpg
Closeout_boxed_zps90f01135.jpg
closeout_attachment_zpsb7c3ef8e.jpg
 

TMO Supporting Vendors

Top