What did you do to your GT350 or S550 Mustang today?

[JeffV8]

Got the crank in today and rings in pistons. Tomorrow rods and pistons will be installed.. My clone Aluminator will be 4 months ahead of Ford Performance short block.

 

[Bill Pemberton]

Seems so appropriate you are installing MANley Rods, I hear Chevy guys install WOMANley rods, and that only shows their confusion --- literally and figuratively.

That is one pretty bench you have there young man!

 

[JeffV8]

That is one pretty bench you have there young man!

Thanks Bill. I wish I was a young man lol 16 days I will be 66

 

[Bill Pemberton]

Ok, well , nice bench there, then, little brother , ha!

 

[Bill Pemberton]

May be in Nebraska but have some good friends at Katz's and there is not a Deli in the World that compares to that place in my mind!! I think the term " stack it high" must of come from there as their pastrami or corned beef on rye is enough for 2 people!

Thanks TMS, but you probably noticed I put the tow hook on upside down!

 

[JeffV8]

Fitting the crank scraper. Sunday pistons in and finish scraper install.

 

[o-man]

Replaced rear brake pads, installed front pads, loaded up tires, washed car and ready to go to VIR and instruct for regional chapter of Ferrari club next two days

 

[steveespo]

Was at NCM Saturday and Sunday. Set new PB on Toyo RRs Saturday in cold conditions down to 2:20.27. Failed right rear wheel bearing shut me down after two sessions Sunday. Got the bearing repleaced yesterday afternoon and am ready for a go at Road Atlanta on Wednesday.

 

[JeffV8]

Getting there.

 

[JeffV8]

Found out today that my Kooks long tube headers hit my GT500 oil pan. Had to modify it. Turned out great.

 

[mavisky]

Knocked the cobwebs off of my autocross skills.

 

[JeffV8]

Engine and transmission installed today.