The TSB 19-2135 didn't fix my problem. The Shelby spent more time at the shop than on the road this summer. Similar to @VUDU V8 Steve a lot of the sensors, spark plugs, MAF, throttle body, etc have been replaced. It's back in the shop now due to reverse, 3rd and 4th gears in the transmission...

https://www.motorsportreg.com/events/turn2-sept-22nd-late-apexing-ridge-motorsports-park-road-course-turn-2-lapping-770772Afternoon HPDE at The Ridge Motorsports Park

This is the Event Thread for Late Apex with Turn2. Discuss the event below.View full event details here and mark yourself as Going or Not Going

Could you share the TSB #, I'm experiencing the same hesitation. Cleaned the MAF which helped a bit.

Thanks for the suggestions for trailer brands and accessories. I'm currently using a Sloan Qwik load rollback trailer, with the new splitter on front it's a challenge to get on and off and I've pretty much used up the whole trailer. I've been using the Ford tie down hooks with Mac's straps to...

I'm looking at a couple of enclosed trailers to haul my GT350 to the track with a 2019 Raptor. I've been looking at the CargoPro Stealth and Featherlite 4926. What else should I look into and what options are a must have? I thought that there was a thread about this but couldn't find it.

Kwik load rollback trailer. Width works fine for the GT350, fenders come off to get in and out.

If the weather people in CA are anything like they are in WA, this forecast will change at least 4 more times before Thursday

Thanks for the info @THX 138 , I just ran into the same scenario. Getting scheduled to get it fixed now. Anything additional learned after the fix?

I run the RT615K+ on my 03 Cobra and had a lot of great success with the tires. Just wish they'd get them in 19 for the GT350

Thanks for all the great info. Makes the decision process much easier. I'll be giving Lenny at motorsport-tech a calls in the near future.

For this year's winter project I'm going to tackle getting the GT350 ready to use the Apex EC-7 wheels with Michelin Pilot Sport Cup 2's. Pretty much I'm copying @VoodooBoss 's information from the Rotatable GT350 Square... thread. Btw thanks for all the details there.The GT350 is also...

Between the photos and the tool listing by @VoodooStang I was able to figure this out. Don't know what I would have done if I hadn't seen this. Thanks!

Thanks Tim. With all of this I was able to get the caliper off and swap rotors. Whoever decided the placement of the spring for the parking brake cable needs to try uninstalling it. Had a heck of time getting that cable off the lever. Even with the spring compressor tools.

Before jumping into the project of swapping rotors, I saw the thread above about replacing the rear caliper and ebrake cable. Then wondered if the caliper would need to be remove to swap the rotor. Sometimes they do and sometimes they don't. Just wondered if anyone knew off hand.Swapping...