VTBoss302 said:From above
"Matt says to go with the K springs for the firmest set up"
Not necessarily the firmest setup, but the best front to rear spring ratio.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
VTBoss302 said:From above
"Matt says to go with the K springs for the firmest set up"
It's ok to post links to articles and video.Domestic Product said:For those that are interested Vorshlag has a great write up and video of the Bilstein package its a good read. Informative even if you are not interested in the product. For those of us that have tracked our Boss's stock it will have you laughing.
Domestic Product said:http://www.vorshlag.com/product_info.php?cPath=141_142_179&products_id=559
OK there it is. The link that is. See above. Vorshlag rocks.
I have ordered the Vorshlag/Bilstein package with K springs. Along with the White line panhard bar, brace, lower control arms and relocation brackets. I'm like a kid at Christmas can't wait till it all shows up. Want to drive the car at speed with these changes....... Then next on the list from Vorshlag (see a trend here) White line front and rear sway bars, D force wheels 18 x 10 with some sticky rubber mounted. 285/something 4 square. Tires from others, hey its hard to beat tire rack.
I hope to have all installed by the 21st as my next track day is the 22nd at the Ridge. http://www.ridgemotorsportspark.com/
You may want to install the front sway bar at the same time you install the front struts it makes for far less installation time and effort. Thats just me however.
It is a awesome new track here in the pacific nw. Check it out.
boro92 said:Has anyone heard back from the official Vorshlag published spring rates yet?
IIRC, I was told by a representative that the P springs are 175/122 and BTS springs are 134/113.
The rates look low but it's because the published rates are rates at static ride height.
No idea what stock Boss ones are at static height...
Champale said:Modernbeat - Thank you thank you THANK YOU for taking those measurements and posting them! Clears up some misconceptions that people have about various spring rates.
John
boro92 said:Seconded.
This data is super helpful!
To those with P springs -- how are they out on track? The rates are still very low--there must still be a lot of body movement on tighter tracks. Any feedback?
steveespo said:Forget P,K, and T springs, what are the Continental Challenge GS cars running for spring rate. Those setups are going to be the closest to optimal with what we can consider production type suspension systems. Plenty of room to grow into those lap times (i.e. 2:01.xx at Watkins Glen or 55.xx at Lime Rock)
Steve
steveespo said:Forget P,K, and T springs, what are the Continental Challenge GS cars running for spring rate. Those setups are going to be the closest to optimal with what we can consider production type suspension systems. Plenty of room to grow into those lap times (i.e. 2:01.xx at Watkins Glen or 55.xx at Lime Rock)
Steve
VTBoss302 said:Agreed.
Time to spill the beans...
VTBoss302
Brandon302 said:I was just about to say that comp springs are probably trash on even Koni Yellows, would need some serious dampers.
Jimmy Pribble said:I don't know about that. It depends on what you find out the comp rates are. I remember them not being so high. I think I have some info at home that I can report later.
Meanwhile I can tell you that I run 350F/325R with Koni Yellows on my other car (<3000 lbs and not a Mustang ) and it rides/handles beautifully.
modernbeat said:Actually, most spring ratings we read online seem to be rated at almost full compression.
At ride height these are the measurements I took at Vorshlag.
T Springs F127 R180 (Same as stock GT, but lower)
K Springs F188 R221 (Best combo for spring rates and height, must use a stiff front bar)
P Springs F204 R165 (Best spring ratios, but too high for my taste)
2011 GT Brembo F125 R181
2013 GT non-Brembo F110 R150
2012 Laguna Seca F129 R207