- 127
- 34
What's the trick to make it not ding? I haven't put the new belts in but I want to be prepared for when I do (which will probably be this week).
The Mustang Forum for Track & Racing Enthusiasts
Taking your Mustang to an open track/HPDE event for the first time? Do you race competitively? This forum is for you! Log in to remove most ads.
- Welcome to the Ford Mustang forum built for owners of the Mustang GT350, BOSS 302, GT500, and all other S550, S197, SN95, Fox Body and older Mustangs set up for open track days, road racing, and/or autocross. Join our forum, interact with others, share your build, and help us strengthen this community!
When Removing The Stock Seat Belts What Do You Do About The "Dinger"?
- Thread starterRoadRacer78
- Start date
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
- 47
- 16
Switching the Seatbelt Reminder On and Off (Correction)
The PDF and infotainment owner's manuals both have the wrong procedure for turning off the seatbelt reminder chime. That was copied from the S550 manual. The HTML online manual has the correct procedure...
www.mustang7g.com
So on my car I have latched my stock seatbelt behind my seat and also left it unlatched. No chimes that I can remember just dash lights.
- Thread starter
- #4
- 127
- 34
I just read through that thread and I think I came up with the same thing as you. Put race seat and belts in for track day. Plug/ insert street seat belt behind the race seat so the car thinks I'm in the seat with the belt latched. Reverse procedure at the end of the track day when the stock comfy seat goes back in. Is that what you're doing?
The insert worked with my stock seat with harnesses. When I unplugged and removed the stock seat for the race seat, the inner lap belt receptacle and it's wiring went with it. No dings from the car, just an airbag/restraint light
- 47
- 16
I mean, I just turn the reminder off following the procedure. Once disabled it doesn't come back on. You don't have to mess around with a seatbelt plug, and I don't consider a reminder chime to be some sort of life saving safety device. Just don't drive without buckling your seat belt.
- Thread starter
- #7
- 127
- 34
So you removed the female (right hand) seat latch with the seat assembly and you don't get any dinging?
i disabled the beltminder per instructions in the manual and removed all the belts and latches front and rear. no dinging or popups on my dash
Mine is an S650. I’ve removed all factory seats and belts. I get a popup when I first start the car with a question mark on seat belt status, but after pressing “OK” I get no other warnings aside from the airbag light. No dinging at startup or when driving.
Similar threads
