Ok, since I installed BMR front and rear handling springs with FP Track handling struts and shocks I have been plagued with the front spring pig tails and the first coil binding on each other. This creates a ridiculous amount of noise and is not useable for any kind of serious driving. Since BMR’s only guidance is to remove the Vorshlag plates and install the stock upper isolators, the opposite direction that I want to go, I have decided to remove the front springs and relegate them to the trash heap where they belong.

May I ask for recommendations for front springs? The car is a dual use car. Once this issue is resolved I plan on doing 3-4 HPDE events a season and most likely the same number of autocross events. I feel that I will probably do fewer autocross events and more HPDE as I improve my skill level.

So far in my digging around I seem to end back with CM-5310-YB FP springs. Lower rate than the BUMR springs, and why I am asking for input from the TMO group. I am running 285/35/19 Michelin PS4S on 10” wide wheels at the moment.

I am all ears at the moment and if anyone has a set of springs that fit my needs for my ‘17 GT PP1 please let me know.

What's you street/track split for driving? What are you trying to build?

@Paul McWhiskey for the 134th time. Just go talk to Trent and be done with it.

TeeLew said:

What's you street/track split for driving? What are you trying to build?

Click to expand...

The car is occasionally driven. I want to be able to drive it on the street and enjoy it when I do. I put the springs that I have on it now because I thought that it would provide a better handling car on the street and be something that would suffice for me to learn to drive on track. I do not want a track car. I am too old to become a competitive racer. I just want to get out there learn, have fun, and have something that will fill the bill and not become a money pit.

byronj said:

@Paul McWhiskey for the 134th time. Just go talk to Trent and be done with it.

Click to expand...

I might. But, at this point I am not convinced that the front springs aren’t the issue.

If there's anything I've learned in this game it's that the swapping out "lowering springs" looking for better handling is a guessing game at best. The amount of money spent playing mix and match with lowering springs and stock replacement dampers would have gotten you a long way towards a good set of decent coilovers where actual data exists.

You could use the ford handling pack camber plates, which use oem isolated perches. They will still get you a decent amount of camber for occasional track and autocross use.

I did run Steeda handling springs on vorshlag plates with oem style upper perch with no significant noise issue. Occasional odd clunk but it was pretty rare.