- Thread starter
- #61
- 101
- 0
Come on guys who's next..? who needs more down force lol
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Grant 302 said:Sam,
Mine arrived yesterday and looks great!
My bracket comes in tomorrow, and I should have it all buttoned up that afternoon if UPS gets here early enough.
I did bolt it up, and I think I need to have the bumper unhooked to get the last two outer bolts in. And I might slot a couple of the holes in the center/back for ease of installation and use the original bolts/washers.
Thanks!
Grant 302 said:Sam,
Mine arrived yesterday and looks great!
My bracket comes in tomorrow, and I should have it all buttoned up that afternoon if UPS gets here early enough.
I did bolt it up, and I think I need to have the bumper unhooked to get the last two outer bolts in. And I might slot a couple of the holes in the center/back for ease of installation and use the original bolts/washers.
Grant 302 said:
101blur said:Sweet thanks I hope you are happy with it. cheers
Grant 302 said:Very happy Sam! I love it! Thanks for getting it done quickly.
Grant 302 said:I couldn't get the outer two bolts to line-up even with the bumper unhooked. So I took everything apart to check where the holes would line up 'naturally' with just the facia sitting on the splitter. I was able to put bolts in all the holes except for 6, 3 each side, inboard of the outer holes.
Passenger side marked:
Driver side marked:
Driver side drilled:
Passenger side drilled:
Facia bolted to splitter top side:
Under side view. I used the oem bolts and washers in the siamesed holes:
DONE!
Grant 302 said:Just to be clear for everyone else, I'm perfectly happy with the splitter! I knew that as a prototype, that some drilling or tweaking might be needed.
I didn't take measurements, but I think they are all less than 1/2" out and are mostly outward. The 'front' one is siamesed with the existing hole so that's just less than 1/4" and the other two are maybe 3/8" out and only slightly forward. I used a 1/4" bit since I was using my facia as a template. Looks like you're using a 5/16" so there should be a bit of wiggle room.
Thanks again Sam!
TymeSlayer said:I am interested in getting either the WC or LS version for my 2012 - with the Boss 302 engraving and the stanchion hardware.
101blur said:Looking for someone that's interested in testing a prototype rear diffuser kit.. DM for more info
THRAPY said:Just got my fender spats last night. Do you have any closeup pics of how it's aligned and mounted?
superhero said:I was told Mine arrived yesterday late afternoon. Didnt even have time to look at it. Hopefully this week end I'll have some time.
Grant, I sure do like the look and the added touches....BOSS 302
How much bigger is it from the WC splitter. It looks like it bigger than the WC but smaller than the LS.