My best time slip

[unrealford]

Here's my best time slip from this summer..

Car was stock, with 15x10 drag radials, and a MGW shifter, Steeda Upper Control Arm.
Here's video
http://m.youtube.com/watch?v=dd5E2ST4lWY

 

[Keavdog]

Nice! Congratulations. What rpms are you launching at? Using launch control with the trac key?
Nice 60'. Imagine with slicks and skinnies!

 

[unrealford]

I added the video of that run to the first post.

I'm launching without launch control, I'm launching about 3,800 to 4,200..

I installed a CAI and tune since, but when I tried to run it at track it just bogged till the point where it took almost 7 seconds to finally pick up RPMs, I was told it was because the tune didn't have Torque management wasn't disabled and when it sees high torque applied to clutch it pulls back power to prevent clutch slippage. Track Key never gave me issues.

I also ran a 11.97 @115

 

[VoodooBoss]

That's an impressive time. I'm glad to see our first new post in this forum!

 

[seca954]

What was the air temperature at the time?

 

[unrealford]

70s with DA of 1,000 ft

 

[BrianDeTienne]

What wheels are you using? Do you have any issues with brake clearance?

 

[unrealford]

Im using Race Star Wheels, they clear the brakes on front and back, Im not using front yet.

 

[BrianDeTienne]

15 x 8?

 

[unrealford]

15x10, but 15x8 would work and then you woundt need a relocation bracket for swarbar.

I had to relocate the swaybar for the 15x10s

 

[BrianDeTienne]

15x10, but 15x8 would work and then you woundt need a relocation bracket for swarbar.

I had to relocate the swaybar for the 15x10s

Thank you for your reply. I had read the same about the 15x10s on another forum and was looking for confirmation.