I plan to install the insert this weekend. Should I drill a hole in it or not? Is it easy to slide it bak out if I want to try it as is, but decide to drill it later?
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
WinterSucks said:Probably a drive shaft loop.
Hermes said:I just put mine in yesterday. No issue what so ever with NVH. Definitely try it as is before you drill it out. I put some grease [none supplied in my pack] on mine before I put it in and ended up taking it out pretty easily.
By the way the article in this months Mustang 5.0 shows the guy installing from back to front, but the instruction said to install front to back [just like the video] which is what I ended up doing and why I pulled it out.
Also, there is very little torque on those cross member bolts. The torque sheet I found said 35 ft-lb which I didn't think was right so I took the bolts off with a TQ wrench and sure enough not even 35 ft lb.